My curved, two-piece sofa needs to be recovered, but because it’s eight-and-a-half feet long it would cost a small fortune to have it reupholstered. It’s also about nine inches longer than conventional sofas, so finding a slip cover that will fit is easier said than done.
For the past few years my sofa has been covered either with an ill-fitting, second-hand slip cover or a pair of thick, white, twin-size bedspreads. Years of abuse from dogs has left stains and small holes in both of those covers, so I’ve spent a lot of time the past few months looking for another option.
One day I realized I had about 8 yards of a nice decorator fabric stashed in a closet. I bought it several years ago to make a duvet cover for an old comforter, but wound up buying a new comforter instead. The golden-tan color works well enough in the living room, so a few weeks ago I pulled out the fabric and realized I had just enough to cover the couch.
I started by folding the long piece of fabric in half to make sure there was enough fabric. There was. I cut it in half, into two long sections—about 12 feet each—and seamed them together lengthwise.
As luck would have it, I’d seamed about two feet before I realized the fabric—which should be right sides together—was wrong-sides together. In my defense the front and back look a lot alike. Can you tell which is which from the side-by-side photo below?
I know, right?
The hardest part of this project was keeping control of such a massive piece of fabric. That meant flipping it over and realigning the edges wasn’t much fun, but I did it. Here it is, properly layered and pinned.
I sewed a straight line from one end to the other, leaving a generous seam allowance. (When the cover is on the sofa, this long seam will be tucked and hidden under the sofa cushions.)
The next step was to trim the ends of the newly-formed piece into straight lines. With both sides together, I folded one cut end to the other, using several large binder clips to keep it properly aligned.
Oops! The ends were a more than a little off, so on each end, I set a right-angle straight-edge over the shorter piece and carefully trimmed the ends so they would be as straight as possible.
After that, all I needed to do was hem all four sides of the massive piece of fabric. Because I wanted a neat and durable finish, I folded the edge over itself so the raw edges wouldn’t show, then pinned it into place.
If the fabric weren’t so cumbersome, I would have pressed the seams flat before sewing, but it worked out fine anyway.
To recap, I:
- cut a long bolt of fabric (approximately 24 feet) into two 12 foot sections
- pinned the right sides together (after noticing I’d done it the wrong way first)
- sewed one long straight line
- folded it end-to-end and trimmed the ends in straight lines
- double-folded the hem and sewed around the entire piece
The only thing left was to try it on the sofa.
Yes, it’s a bit wrinkled, but the fabric had been piled up on the table several days as I pinned and stitched away. The wrinkles will come out in the wash. Between my dog Sadie, who’s napping on the sofa at this very moment, and our frequent guest dog Stanley, this new sofa cover will be washed quite often.